Selling Point Descriptions - Hitachi C 6SE Technical Data And Service Manual

Table of Contents

4-1. Selling Point Descriptions

(1) Double-insulated construction

Grounding is not required because of the double-insulated construction.

(2) Power-plus heavy duty motor

Powerful motor provides greater input and output than those of the Models C6 and C7.

(3) High performance 40-tooth tungsten carbide tipped (TCT) saw blade as standard

High performance TCT saw blade (40 teeth) is provided as standard instead of the conventional combination

blade. The Models C 6SE and C 7SE provide greater maximum cutting depth than the conventional models

by using a 165 mm dia. TCT saw blade and a 190 mm dia. TCT saw blade respectively.

(4) Improved operability with large front grip, large plastic wing bolt & nut for base adjustment, and large lever on

the safety cover

The circular saw can be stably handled with both hands because the front grip is formed with the housing as

one piece. The inclination adjusting wing bolt and cutting depth adjusting wing nut were changed from steel to

plastic for better operability. A large safety cover knob is adopted for easier opening and closing of the safety

cover.

(5) Convenient cutting depth scale on the safety cover

A cutting depth scale is marked in millimeters on

the safety cover. By aligning the bottom of the

base with the scale, you can easily set the

desired cutting depth. The inner scale is for a

160 mm dia. saw blade on the C 6SE or for a

185 mm dia. saw blade on the C 7SE, and the

outer scale is for a 165 mm dia. saw blade on the

C 6SE or for a 190 mm dia. saw blade on the

C 7SE. Both scales are graduated in 3

millimeters. An example, when the cutting depth

is adjusted to 30 mm, is shown in Fig. 1.

Notes on using the cutting depth scale

• This scales should only be used as a rough guide. If more accurate adjustment is required, instruct the

customers to measure the saw blade tip directly from the bottom surface of the base.

• As the scale indicates a cutting depth when the saw blade is at a right angle to the base, it cannot be used

for inclined cutting.

--- 2 ---

Fig. 1

Table of Contents

Show Quick Links

Table of Contents