Adjusting The Cutting Height; Adjusting The Handle Height; Starting The Engine - Toro 20381 Operator's Manual
Super recycler
Hide thumbs
Also See for 20381:
- Operator's manual (28 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (25 pages)
Table of Contents
Advertisement
Adjusting the Cutting Height
WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing when
adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you. Keep away from the
hot muffler.
Adjust the cutting height as desired. Set all four wheels to
the same height.
Note: To raise the machine, move all 4 cutting height levers
forward; to lower the machine, move them all rearward
(Figure 11).
Adjusting the Handle Height
You may raise or lower the handle to a position comfortable
for you.
Rotate the handle lock, move the handle to 1 of 3 positions,
and lock the handle into position (Figure 12).
G017462
Figure 11
1. Handle lock
Starting the Engine
1. Pull the blade-control bar to the handle (Figure 13).
2. Push the electric-start button (electric-start model only)
(Figure 14) or pull the recoil start handle (Figure 15).
Note: If the electric-start button has been removed,
insert it in the electric starter; refer to Figure 14
(electric-start model only).
10
Figure 12
2. Handle positions
Figure 13
Hide quick links:
Advertisement
Table of Contents
