Lubricating The Wheel Gears; Replacing The Blade; Cleaning The Machine - Toro 20381 Operator's Manual
Super recycler
Hide thumbs
Also See for 20381:
- Operator's manual (28 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (25 pages)
Table of Contents
Advertisement
Note: Your machine comes with a spare fuse in the
battery compartment.
3. Install the battery cover.
Lubricating the Wheel Gears
Service Interval: Every 25 hours
1. Wipe the grease fittings just inside the rear wheels with
a clean rag (Figure 39).
1. Grease fitting
2. Install a grease gun onto each fitting and gently apply 2
or 3 pumps of #2 multi-purpose lithium-base grease.
Replacing the Blade
Service Interval: Before each use or daily
Every 25 hours—Replace the blade or have it
sharpened (more frequently if the edge dulls quickly).
Important: You will need a torque wrench to install the
blade properly . If you do not have a torque wrench or
are uncomfortable performing this procedure, contact
an Authorized Service Dealer.
Examine the blade whenever you run out of gasoline. If the
blade is damaged or cracked, replace it immediately. If the
blade edge is dull or nicked, have it sharpened or replace it.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Wear gloves when servicing the blade.
Figure 38
Figure 39
1. Disconnect the spark plug wire from the spark plug.
Refer to Preparing for Maintenance (page 17).
2. Tip the machine onto its side with the air filter up.
3. Use a block a wood to hold the blade steady (Figure 40).
4. Remove the blade, saving all mounting hardware.
5. Install the new blade and all mounting hardware.
Important: Position the curved ends of the blade
to point toward the machine housing.
6. Use a torque wrench to tighten the blade bolt to
60 ft-lb (82 N-m).
Important: A bolt torqued to 60 ft-lb (82 N-m) is
very tight. While holding the blade with a block
of wood, put your weight behind the ratchet or
wrench and tighten the bolt securely. This bolt is
very difficult to overtighten.
Cleaning the Machine
Service Interval: Before each use or daily
WARNING
The machine may dislodge material from under the
machine housing.
• Wear eye protection.
• Stay in the operating position (behind the
handle) when the engine is running.
• Do not allow bystanders in the area.
20
Figure 40
Hide quick links:
Advertisement
Table of Contents
