Setup; Assembling And Unfolding The Handle - Toro 20381 Operator's Manual
Super recycler
Hide thumbs
Also See for 20381:
- Operator's manual (28 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (25 pages)
Table of Contents
Advertisement
1. Warning—read the Operator's Manual for information on charging the battery; contains lead; do not discard.
2. Read the Operator's Manual.
115-2896
Electric-start model only
115-8411
1. Unlocked
Electric-start model only
2. Locked
104-7953
Setup
Important: Remove and discard the protective plastic
sheet that covers the engine.
1
Assembling and Unfolding the
Handle
No Parts Required
Procedure
WARNING
Assembling and unfolding the handle improperly
can damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when assembling and
unfolding the handle.
• Ensure that the cables are routed to the outside
of the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Raise the rear of the machine housing to its highest
cutting height setting by moving the 2 rear cutting
height levers all the way forward. Refer to Adjusting
the Cutting Height (page 10).
5
Hide quick links:
Advertisement
Table of Contents
