Installing The Starter Rope - Toro 20381 Operator's Manual
Super recycler
Hide thumbs
Also See for 20381:
- Operator's manual (28 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (25 pages)
Table of Contents
Advertisement
2. Attach the handle ends to the machine housing with
2 washers and 2 handle bolts (Figure 3), but do not
tighten the handle bolts.
Figure 3
1. Washer
2. Handle bolt
Important: Route the cables to the outside of the
handle (Figure 3).
3. Rotate the handle rearward (Figure 4).
Figure 4
4. Lock the handle at your desired height. Refer to
Adjusting the Handle Height (page 10).
G017457
3. Handle end
G017458
5. Torque the handle bolts to 120 to 160 in-lb (14 to 17
N-m).
6. Adjust the cutting height. Refer to Adjusting the
Cutting Height (page 10).
2
Installing the Starter Rope
No Parts Required
Procedure
Important: To start the engine safely and easily
whenever you use the machine, install the recoil-starter
rope in the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(Figure 5).
1. Recoil-starter rope
6
Figure 5
2. Rope guide
Hide quick links:
Advertisement
Table of Contents
