Checking The Engine Oil Level - Toro 20381 Operator's Manual
Super recycler
Hide thumbs
Also See for 20381:
- Operator's manual (28 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (25 pages)
Table of Contents
Advertisement
G017461
Figure 9
2. Fill the fuel tank, leaving at least 1 cm (1/2 inch) from
the bottom of the neck empty to allow the gasoline
room to expand.
3. Install the fuel tank cap and tighten it securely by hand.
½ inch (1 cm)
Checking the Engine Oil Level
Service Interval: Before each use or daily
Max. fill: 20 oz. (0.59 l), type: SAE 30 or SAE 10W-30
detergent oil with an API service classification of SF, SG, SH,
SJ, SL, or higher.
1. Move the machine to a level surface.
2. Remove the dipstick (Figure 10).
1. The oil level is at its
maximum.
2. The oil level is too
high—remove oil from
the crankcase.
3. Wipe off the dipstick end with a clean cloth.
4. Insert the dipstick into the oil-fill tube, but do not
screw it in.
5. Remove the dipstick and read the oil level; refer to
Figure 10.
•
If the oil level is too low, add a small amount of
oil slowly to the oil-fill tube, and then repeat steps
3 through 5 until the oil level on the dipstick is
correct.
•
If the oil level is too high, drain the excess oil until
the oil level on the dipstick is correct. To drain the
excess oil, refer to Changing the Engine Oil (page
18).
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
6. Install the dipstick securely.
9
G017459
Figure 10
3. The oil level is too
low—add oil to the
crankcase.
Hide quick links:
Advertisement
Table of Contents
