Table of Contents
Advertisement
Advanced Functions (Continued)
Zone 2 temperature shows the temperature reading of the top probe
without offset.
Advanced Setup Mode (Re-calibration)
To change offset temperature or run on only 1 probe enter the following key sequence.
Advance through all parameters by using the
parameters except the ones listed below. This is only required after a probe fails. The
parameters are as follows.
Default is 2, 1 can be used when only the top probe is working.
and
and 2.
0690S20046
690-NC2
adjust with the up and down key for temperature offset for probe 1
key. Do not change any of the
Continued
6-6
Advertisement
Table of Contents
