Table of Contents
Advertisement
Installing the Router Case
The router can be placed on a desktop or mounted in a 19" rack, depending upon your need. Regardless of where you place
the router make sure its cable jacks are accessible, LED indicators are visible and its ventilation holes are never blocked.
Installing the Router Case on Table
D-Link DI-1750 router may be placed on a smooth and secured table. Please check the access of power & communication
cables to the installation workplace.
Note: Do not place any heavy object on the router, this may damage the router.
Installing the Router Case in a 19" Rack
D-Link DI-1750 router can be fixed in a 19" rack using brackets provided with the router. When locking the case, ensure the
front panel of the router faces front. As illustrated below:
Note:
The above example illustrates only one side of the installation; the other side of the router bracket installation will be at a
corresponding location of the case.
After the bracket is installed, you can install the router on the rack, the operation is illustrated in the following figure:
Connecting Power to the Router
Recommended AC power socket
A Three-pin power socket with a neutral point connector or a special power socket for the computer is recommended. The
neutral point of the power supply system in a building must be reliably grounded before connecting the AC power cord of the
router. Normally, the neutral point of the power supply system in a building will have been grounded during the construction
and wiring.
Connecting AC power cord
1. Confirm that the GND wire is correctly grounded.
2. Make sure that the power switch of the router is turned off, connect one end of the power cord to the AC input
socket on the router's rear panel, and connect the other end to the AC outlet.
12
DI-1750 Router
Advertisement
Table of Contents
