Table of Contents
Advertisement
DI-1750 Router
3. Switch the power switch of the router to ON position.
4.
Check that the PWR LED on the front panel of the router is ON.
Connecting to the Console & Auxiliary Port of the Router
There is one Console port and one AUX port on D-Link DI-1750 Router. This section describes the features and usage of
these two ports.
Console Port
Transmission Rate supported is 1200bps-to-115200bps and it has a standard RJ45 Connector, Parity Check is optional, and
has Flow Control. A dedicated Console cable, DRC-0001, provided with the router is used to connect this port to a terminal
device like VT-100, or to the serial port of PC, and then use a terminal emulator (such as Windows Hyper terminal software)
to configure & monitor the D-Link DI-1750 Router functions. The communication parameter of the serial port on a PC has to
be set as: Rate: 9600bps rate, eight-bit data bits, one-bit stop bit, no Parity Check bit, and no flow control as shown in Figure :
The RJ-45 connector of the Console port is shown in the following figure, the male and female connectors are pin-to-pin
corresponding and the pin numbers 1-8 start from left to right.
The connection between the Console port of D-Link 1750 Router and the terminal device or PC serial port is illustrated as
below:
_______________________________________________________________________
13
Advertisement
Table of Contents
