Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for 909 BG200
Summary of Contents for 909 BG200
- Page 1 INSTRUCTION MANUAL BG200 3 /4HP BENCH GRINDER...
-
Page 2: Table Of Contents
CONTENTS Warranty Warranty Power Tools Introduction For full details please visit us at www.909.com Environmental protection Description of symbols Specifications General safety rules Additional safety rules for bench grinders Unpacking Setting up Know your product Fitting and adjusting the spark deflectors and eye shields... -
Page 3: Environmental Protection
Cautions and Warnings. For safe operation read instruction manual. Your 909 power tool has many features that will make your job faster and easier. Safety, performance, and dependability have been given top priority in the... -
Page 4: General Safety Rules
General safety rules 3) Personal safety a) Stay alert, watch what you are doing and use WARNING. Read all safety warnings and all instructions. common sense when operating a power tool. Do not Failure to follow the warnings and instructions may result in use a power tool while you are tired or under the electric shock, fire and/or serious injury. -
Page 5: Additional Safety Rules For Bench Grinders
b) Do not use the power tool if the switch does not turn b) If the supply cord is damaged, it must be replaced by it on and off. Any power tool that cannot be controlled the manufacturer, its service agent or similarly qualified with the switch is dangerous and must be repaired. -
Page 6: Unpacking
Due to modern mass production techniques, it is unlikely The bench grinder can be fitted with a wire wheel provided that your 909 Power Tool is faulty or that a part is missing. that the wheel is rated for use at 3000 RPM or higher. -
Page 7: Know Your Product
Know your product 1. On/off switch 2. Tool rest 8. Wheel guard 3. Tool rest locking bolts 9. Grinding wheel 4. Eye shield 10. Grinding wheel locking nut 5. Eye shield locking knob 11. Base 6. Spark deflector 12. Wheel guard cover screws 7. -
Page 8: Fitting And Adjusting The Spark Deflectors And Eye Shields
the spark guard gap, rotate the wheel by hand a full CAUTION. During use it is important not to overload the revolution to ensure there is grinder. The grinder should run at close to full speed. If no contact with the wheel. you are applying too much pressure the grinder will start to slow down. -
Page 9: Fitting The Tool Rests
Bench mounting the grinder Fitting the tool rests The 909 bench grinder is supplied with 4 rubber mounts The tool rests (2) are required for each high speed grinding which assist in reducing the transmission of vibration. wheel to assist in the grinding operation. -
Page 10: Work Lights
Work lights Note. The wheel on the left- hand side of the bench grinder The work lights (7) are directly connected to the grinder On/ has a left-hand thread and Off switch They will come on every time the bench grinder is is unscrewed in a clockwise turned on, and will turn off when the grinder is turned off. -
Page 11: Operation
4. Adjust the tool rest so that it is no more than 1.5mm Operation from the wheel. IMPORTANT. Prior to using the grinder, check that the 5. Adjust the spark deflector to ensure the gap between eye shields, spark deflectors, and tool rests are fitted and the deflector and wheel is less than 6mm. -
Page 12: Power Cord Maintenance
Power cord maintenance If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer’s agent, or an authorised service centre in order to avoid a safety hazard. Cleaning 1. Remove dust and dirt regularly. Cleaning is best done with a soft brush or a rag.