Important Notices - Bosch WZ14 Installation Manual
Integrated ir bullet camera
Hide thumbs
Also See for WZ14:
- Installation manual (24 pages) ,
- Installation and operation manual (14 pages)
Table of Contents
Advertisement
WZ14 Integrated IR Bullet Camera
17. Do not attempt to open or disassemble the camera to gain access to the internal
components. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in a way, such as power-supply
cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, does not operate normally, or has dropped. When servicing, power
shall be disconnected.
18. These servicing instructions are for use by qualified service personnel only.
To reduce the risk of electric shock, do not perform any servicing other than that
contained in the operating instructions, unless you are qualified to do so.
1.3
Important Notices
Accessories - Do not place this unit on an unstable stand, tripod, bracket, or mount.
The unit may fall, causing serious injury and/or serious damage to the unit. Use only
with the cart, stand, tripod, bracket, or table specified by the manufacturer. When
a cart is used, use caution and care when moving the cart/apparatus combination
to avoid injury from tip-over. Quick stops, excessive force, or uneven surfaces may
cause the cart/unit combination to overturn. Mount the unit per the manufacturer's
instructions.
All-pole power switch - Incorporate an all-pole power switch, with a contact
separation of at least 3 mm in each pole, into the electrical installation of the
building. If it is needed to open the housing for servicing and/or other activities, use
this all-pole switch as the main disconnect device for switching off the voltage to the
unit.
Camera grounding - For mounting the camera in potentially damp environments,
ensure to ground the system using the ground connection of the power supply
connector (see section: Connecting external power supply).
Camera lens - An assembled camera lens in the outdoor housing must comply and
be tested in accordance with UL/IEC60065. Any output or signal lines from the
camera must be SELV or Limited Power Source. For safety reasons the environmental
specification of the camera lens assembly must be within the environmental
specification of -10 °C to 50 °C (14 °F to 122 °F). Camera signal - Protect the cable
with a primary protector if the camera signal is beyond 140 feet, in accordance with
NEC800 (CEC Section 60).
Camera signal - Protect the cable with a primary protector if the camera signal is
beyond 140 feet, in accordance with NEC800 (CEC Section 60).
Coax grounding:
– Ground the cable system if connecting an outside cable system to the unit.
– Connect outdoor equipment to the unit's inputs only after this unit has had its
grounding plug connected to a grounded outlet or its ground terminal is properly
connected to a ground source.
– Disconnect the unit's input connectors from outdoor equipment before
disconnecting the grounding plug or grounding terminal.
– Follow proper safety precautions such as grounding for any outdoor device
connected to this unit.
U.S.A. models only - Section 810 of the National Electrical Code, ANSI/NFPA No.70,
provides information regarding proper grounding of the mount and supporting
structure, grounding of the coax to a discharge unit, size of grounding conductors,
location of discharge unit, connection to grounding electrodes, and requirements for
the grounding electrode.
Disposal - Your Bosch product was developed and manufactured with high-quality
material and components that can be recycled and reused. This symbol means that
electronic and electrical appliances, which have reached the end of their working
life, must be collected and disposed of separately from household waste material.
Separate collecting systems are usually in place for disused electronic and electrical
products. Please dispose of these units at an environmentally compatible recycling
facility, per European Directive 2002/96/EC.
Bosch Security Systems, Inc.
Installation Manual
Safety | en
5
| 2.0 | 2010.12
Advertisement
Table of Contents
