Advertisement
Installing the Unit
Guidance Screen
Mount to the windscreen using suction
mount and ram arm, or unscrew the
ball from the suction mount and use
this for a permanent fixture.
Magnetic Receiver
Install on the roof of the
vehicle with arrow
pointing to the front (if
the roof is not metal use
the roof mount plate
supplied).
12v DC Plug
Plug into 3 pin socket
on vehicle. (If hard
wiring do not remove
the fuse).
Warranty Void if suction mount fails !!
is removed from the windscreen when the unit is not in operation and reat-
tached on a day to day basis.
For a more permanent fixing please detach the ram ball from the suction mount
and secure down in the vehicle.
– Please disconnect the unit from the power
Warning
supply, if you need to jump start your vehicle.
Quick Start Guide
Touch Screen
Brightness
Power On/Off
- Its is advised that the suction mount
PWdoc0007 rev.2.3
Advertisement
Table of Contents
Summary of Contents for PATCHWORK Advance
-
Page 1: Quick Start Guide
Quick Start Guide Installing the Unit Guidance Screen Touch Screen Mount to the windscreen using suction mount and ram arm, or unscrew the Brightness ball from the suction mount and use Power On/Off this for a permanent fixture. Magnetic Receiver Install on the roof of the vehicle with arrow pointing to the front (if... -
Page 2: Navigation Bar
Setup When launching the BlackBox for the first time the ‘Setup Wizard’ will run through the essential settings ready for guidance and area measurement. Navigation Bar Previous Next Home Information Cancel Confirm N.B. The wizard can be re-accessed via Setup > Save/Load Profile > Run Initial Setup Wizard. -
Page 3: Guidance Screen
Guidance Screen Only available when using section control Start/Pause Boundary Close *Purge Boundary On/Off Guidance *Purge Toggle Settings Recording Menu On/Off Information Panel Guidance Status Speed (Toggle Speedometer / Digital) GPS Strength Current Rate/Width Coverage Area Distance Travelled Measuring the Area of a Field 1) After starting a new job, position your vehicle at the edge of the field and press the Start/Pause Boundary. - Page 4 Setting and Using a Guidance Line 1) Position the vehicle in the field where the job will begin. (When using a curved line it is important to use the longer edge of the field to set a guide line). 2) At the beginning of a straight run press Grid area Grid area...