Control Codes; Cable Connection; Lan Connector - NEC X464UN Installation Manual
46” led lcd display
Hide thumbs
Also See for X464UN:
- User manual (57 pages) ,
- Installation manual (3 pages) ,
- User manual (53 pages)
Table of Contents
Advertisement
X464UN Installation Guide
46" LED LCD Display
Control Codes
NOTE: Contact your NEC rep for codes not listed.
NOTE: Use a cross/reverse/null modem cable.
Cable Connection
Communication Protocol:
Interface:
Communication:
Baud Rate:
Data Length:
Parity:
Stop Bit:
Communication Code:
PC Control Connector (D-Sub 9P)
NOTE:
If so desired, jumper "Request to send" and "Clear to Send" together on both ends of the cable to simplify cable connection. These
connections are not required. The only connections required are pins 2 (TxD), 3 (RxD) and 5 (GND)
www.necdisplay.com
RS-232C
Asynchronous
9600 bps
8 bits
None
1 bit
Hex
NEC Display Solutions of America, Inc.
Interface:
Communication Layer:
IP Address:
Port Number:
LAN Connector
Transmit Data+
Transmit Data-
Receive Data+
Not Used
Not Used
Receive Data-
Not Used
Not Used
X464UN
Rev 1.0
TCP/IP (Ethernet)
Transport Layer (TCP)
192.168.0.10 (Default)
7142 (Fixed)
Page 6 of 7
Advertisement
Table of Contents
