Table of Contents
Advertisement
Coaxial SCS Menu
Item
TRAY1
COR*
TRAY2
C-PORT
TRAY3
PORT
AUX
LAND
APO
ENABLE*
DISABLE
LPI
6*
8
0
LINE SPACING
1*
2
Value
Specifies the default orientation for jobs printed from each tray.
TRAY1 is the standard 500-sheet input tray. TRAY2 is the lower
500-sheet input tray if one optional 500-sheet tray is installed, it is
the middle 500-sheet tray if two optional 500-sheet trays are
installed. TRAY3 is the lowest 500-sheet tray when two optional
500-sheet trays are installed. Each input can be assigned one of the
following default orientations:
v COR—computer output reduction: Printing in landscape with the
logical page reduced to fit more data on the physical page. The
printer reduces vertical spacing and uses a smaller font with less
space between letters.
v C-PORT—compressed portrait: printing in portrait, but with
horizontal and vertical compression.
Horizontal compression makes it possible to print 80 characters
per line in portrait when 10 cpi is used and 133 characters per
line when 16.7 cpi is used. The horizontal compression factor
differs depending on paper size used. Because of this, no
horizontal compression can be seen when Letter paper is used
because Letter paper in portrait already allows 80 characters in
10 cpi.
Vertical compression makes it possible to print 66 lines per page
in 6 LPI or 88 lines per page in 8 LPI. The vertical compression
factor also varies depending on the paper size used.
v PORT—portrait: the page has normal, upright business letter
orientation. For envelopes from the auxiliary tray, PORT specifies
normal envelope orientation.
v LAND—landscape: the page is wider than long.
Enables or disables automatic print orientation.
v ENABLE—if the requested dimensions of the job fit on the paper,
the page is printed either in portrait or landscape, whichever
better fits the dimensions. If the requested dimensions do not fit
on the paper, the default orientation for the tray (COR, PORT,
LAND, or C-PORT) determines how the sheet is printed.
v DISABLE—the page prints using the default orientation for the
tray (COR, PORT, LAND, or C-PORT).
Notes:
1. Values specified in the data stream override values set at the
printer.
2. The factory defaults (orientation set to COR and APO=ENABLE)
give you the most flexibility.
3. The requested dimensions are determined by the values of CPI,
LINE SPACING, MPP, and MPL for the job. These values can be
set in the data stream or on the Coaxial SCS Menu.
Specifies a default lines per inch value for jobs received over the
coax attachment. Valid values are 0, 6, and 8. The default is 6 lines
per inch. 0 specifies either the value specified in the job, or the PCL
default value for the printer.
Specifies single or double spacing:
v 1—single spacing
v 2—double spacing
Description
Chapter 6. Operator Panel Menus
91
Advertisement
Table of Contents
