Table of Contents
Advertisement
Checking Communication Environment
2.1.1.
Before installing ezTCP, the user must check conditions of the network to install the
ezTCP as follows:
Wireless LAN network types (infrastructure/ad-hoc)
the SSID and the channel of the wireless LAN
Whether to use WEP and WEP setup values (the number of bits and key
values)
Authentication Protocol for wireless LAN access
IP address environment (Local IP, subnet mask, gateway, etc.)
Serial port items of the device to connect (baudrate, databit, parity, and stop
bit)
Protocol of the application program to use (TCP/UDP, server/client, etc.)
For more information about the wireless LAN, see
Wireless LAN."
For more information about protocol of the application program to use, see
"
4.3 Normal Communication Mode.
※
It is not applicable to a wireless LAN which use authentication, because ezTCP
doesn't support authentication protocols for the wireless LAN
Configuring the Wireless LAN
2.1.2.
Before using the ezTCP, the user must set wireless LAN-related items. Wireless LAN-
related items can be set via ezSerialConfig in a serial configuration mode. Supply
power without the PCMCIA card insertion to enter into the serial configuration
mode. In the serial configuration mode, the user can set not only wireless LAN-related
items but also all setup values of the ezTCP.
For more information about the serial configuration mode, see
Modes."
For more information about wireless LAN-related items in serial configuration
mode, see
"
3.1 Configuring the Wireless LAN.
Connecting to the Network
2.1.3.
Insert the PCMCIA card while power is not supplied. Then, connect the device with the
"
"
- 10 -
"
3.1 Configuring the
"
4. Operation
Advertisement
Table of Contents
