Removing And Installing The System-Board Shield - Lenovo ThinkCentre E63z User Manual
Lenovo thinkcentre e63z all-in-one desktop
Hide thumbs
Also See for ThinkCentre E63z:
- Hardware maintenance manual (164 pages) ,
- User manual (102 pages) ,
- Safety, warranty, and setup manual (2 pages)
Table of Contents
Advertisement
7. To install the new internal speakers, position the new internal speakers on the LCD front bezel so that
the screw holes in each internal speaker align with the corresponding holes in the front bezel. Then,
install the four screws to secure the internal speakers to the LCD front bezel.
Figure 18. Installing the internal speakers
8. Route the cable of new internal speakers, and then connect the cable to the system board. See
"Locating parts on the system board" on page 32.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 127.
Removing and installing the system-board shield
This section provides instructions on how to remove and install the system-board shield.
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To remove and install the system-board shield, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the frame stand. See "Removing and installing the frame stand" on page 99.
4. Remove the computer cover. See "Removing the computer cover" on page 102.
106
ThinkCentre E63z User Guide
Advertisement
Table of Contents
Troubleshooting
