Replacing The System Fan - Lenovo ThinkCentre E63z User Manual
Lenovo thinkcentre e63z all-in-one desktop
Hide thumbs
Also See for ThinkCentre E63z:
- Hardware maintenance manual (164 pages) ,
- User manual (102 pages) ,
- Safety, warranty, and setup manual (2 pages)
Table of Contents
Advertisement
Figure 33. Installing the control-button board
9. Route the cable of the control-button board, and then connect the cable to the system board. See
"Locating parts on the system board" on page 32.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 127.
Replacing the system fan
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
This section provides instructions on how to replace the system fan.
To replace the system fan, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the frame stand. See "Removing and installing the frame stand" on page 99.
4. Remove the computer cover. See "Removing the computer cover" on page 102.
5. Remove the system-board shield. See "Removing and installing the system-board shield" on page 106.
6. Record the routing of the system-fan cable, and then disconnect the cable from the chassis.
116
ThinkCentre E63z User Guide
Advertisement
Table of Contents
Troubleshooting
