Installing A Drive - IBM 6339 User Manual

Hide thumbs Also See for 6339:

Table of Contents

Installing a drive

User Guide

The following illustration shows the locations of the drive bays

The following table describes some of the drives that you can install in each bay

and their height requirements.

1 Bay 1 - Max Height: 25.4 mm (1.0 in.)

2 Bay 2 - Max Height: 41.3 mm (1.6 in.)

3 Bay 3 - Max Height: 12.7 mm (0.5 in.)

Notes:

1. Drives that are greater than 41.3 mm (1.6 in.) high cannot be installed.

2. Install removable media (tape or CD) drives in the accessible bay: bay 1 or 2.

To install a CD drive or DVD drive in bay 2, follow these steps.

1. Remove the cover (see "Removing the cover" on page 19).

2. If you are installing a drive with removable media, insert a flat–blade

screwdriver into one of the slots on the static shield in the drive bay into

which you installed the drive and gently pry the static shield loose from the

drive bay.

3. Make sure the drive is set correctly as the master device. Refer to the

documentation that comes with your CD drive or DVD drive for master/slave

jumper information.

4. Lift the latch and remove the drive mounting tray.

5. Install the drive into the bay. Align the screw holes and insert the four screws.

6. Slide the drive cage halfway into the mounting tray.

3.5-inch diskette drive (preinstalled in some

models)

CD-ROM drive (standard in some models)

3.5-inch hard disk drive (preinstalled)

Table of Contents