IBM 6339 User Manual page 47

Hide thumbs Also See for 6339:

Table of Contents

User Guide

Refer to the documentation that comes with your drive for master/slave

jumper information.

7. Install the drive into the bay. Align the screw holes and insert the two screws.

8. Pivot the drive bay cage back into place.

9. Each integrated drive electronics (IDE) drive requires two cables; a four-wire

power cable that connects to the power supply and a signal cable that connects

to the system board. You might also have an audio cable to connect.

The steps to connect an IDE drive are different depending on the type of drive you

are connecting. Locate the procedure below for your drive connection.

To connect the first IDE CD drive or DVD drive

1. Locate the three-connector signal cable that came with your computer or with

the new drive.

2. Locate the secondary IDE connector and CD-ROM audio connector on the

system board. See "Identifying parts on the system board" on page 30.

3. Connect one end of the signal cable to the drive and the other to the secondary

IDE connector on the system board. To reduce electronic noise, use the

connectors at the end of the cable only.

Table of Contents

6346 6341 6342 6348 2256 2257 ... Show all