Installing A Drive - IBM 6339 User Manual

Hide thumbs Also See for 6339:

Table of Contents

Installing a drive

To install an internal drive, follow these steps.

1. Remove the cover. See "Removing the cover" on page 41.

Note: If your computer has a CD drive or DVD drive, you might need to

remove the signal and power cables from the drive.

2. Remove the bay panel from the drive bay by inserting a flat-blade screwdriver

at the end and gently prying it loose.

3. Remove the metal shield from the drive bay by inserting a flat-blade

screwdriver into one of the slots and gently prying it loose.

4. Make sure the drive that you are installing is set correctly as either a master or

a slave device.

v If it is the first CD drive or DVD drive, set as a master device.

v If it is an additional CD drive or DVD drive, set as a slave device.

v If it is a hard disk drive, set as a slave device.

Refer to the documentation that comes with your drive for master/slave

jumper information.

Chapter 5. Installing internal options — microtower model

Table of Contents