Table of Contents
Advertisement
Power Dome® LT by Wagan Tech
DC OUTPUT SOCKET
The DC accessory socket can power a DC load up to 10 Amps. Overloading the socket will result
in tripping (a self-resetting circuit breaker). Removing the overload automatically restores power to
the DC socket.
1. Check the required current draw of the appliance/device to be powered and make sure it
does not exceed the Power Dome's maximum wattage.
2. Make sure all Power Dome switches are off (including the Master Switch).
3. Remove the dust cover from the DC socket.
4. Insert the 12V DC accessory plug into the socket.
5. Turn the Master Switch on.
6. Operate the appliance as usual.
7. After use, disconnect the accessory plug from the DC socket and store the accessory.
8. Replace the dust cover.
9. Recharge the Power Dome as soon as convenient.
USB POWER PORT
1. Prior to connecting your mobile device, make sure that the Master Switch is turned off.
2. Connect the USB cable to the USB power port on the Power Dome.
3. Turn the Master Switch on.
4. Set the Inverter/USB Switch to "I" position. (You may operate the USB and the inverter at
the same time by setting the Inverter/USB Switch to the "II" position, or just operate the USB
only in the "I" position.)
WORK LIGHT
1. Turn the Master Switch on.
2. Turn the work light switch on
3. The 3 LEDs will illuminate.
4. Turn the light off when it is not in use.
10
®
www.wagan.com
Hide quick links:
Advertisement
Table of Contents
