Table of Contents
Advertisement
TROUBLESHOOTING
Problem
Air compressor shut-off.
Lack of power output.
Television/power
tool will not start.
Television Interference.
Static/noise interference
in audio system.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
Cause
High temperature
protection.
Power Dome battery
voltage is below 10 volts.
Excessive current drawn
by appliance being
operated.
Inverter fuse blown.
Required wattage
exceeds Power Dome
peak surge for start-up.
Picture breaking up
(static)
Sound system has weak
alternating current
shielding.
©2015 Wagan Corporation. All Rights Reserved.
Solution
Allow the Power Dome cool for about 10 minutes.
Recharge the Power Dome immediately.
Reduce load to maximum wattage.
1. Turn off the device and inverter.
2. Disconnect device.
3. Turn the inverter on and let it run for a
minimum of 2 minutes.
4. Turn inverter off.
5. Quickly plug device into inverter.
6. Turn on both the inverter and the device.
Check and replace if necessary. Be sure
replacement fuse is the same type and rating.
Toggle the Inverter/USB Switch on and off in
quick succession for 5 times. If the device does
not start, the device is not compatible with this
type of inverter.
Place the Power Dome as far as possible from
the TV, antenna, and coaxial cable.
TV station may be out of range.
Do not use the Power Dome's inverter with low-
quality audio AC filtering system.
Replace audio system with high quality noise
filtering.
11
Hide quick links:
Advertisement
Table of Contents
