Table of Contents
Advertisement
HDD invalid: "Enable/Disable" 2 options, setup according to the user needs.
HDD full: "Enable/Disable" 2 options, setup according to the user needs.
Trigger: Choose the channels need to be triggered
IP address conflict: "Enable/Disable" 2 options, setup according to the user needs.
Trigger: The processing for alarming, click "settings" display as below:
i. Trigger record: Place a check mark '√' for the channel you need to trigger, when there
is alarm on the setting channel, will trigger to other channels.
ii. Snapshot: Place a check mark '√' in front the channel, when the setting channel has
alarm, will snap a picture.
iii. Send E-mail: Place a check mark '√', when there is alarm, will send the snapped
picture to the mailbox you set.
iv. Alarm output: Place a check mark '√', will trigger the external alarm.
v. Alarm output duration: Click the inverted triangle, options: 10s/ 30s/ 1min/ 3 min/ 5min/
10min/ 15min/ 30min.
vi. Buzzer: Click the inverted triangle, options: None/10s/ 30s/ 1min/ 3 min/ 5min/ 10min/
15min/ 30min.
vii. Pop-out image: Click the inverted triangle, options: None/ CH1/ CH2...
viii. Post-record: Click the inverted triangle, options: 10s/ 30s/ 1min/ 3 min/ 5min/ 10min/
15min/ 30min.
ix. Pre-record: Click the inverted triangle, options: None/ 5s/ 10s
x. Trigger PTZ: None/ Cruise line/ Preset point
xi. Attention: Click "Apply" after setup.
3.2.2 NETWORK
LAN
Obtain an IP address automatically
Use the following IP address:
IP address: Fill in the IP address according to your network settings.
Subnet mask: Fill in the subnet mask according to your network settings.
Default gateway: Fill in the default gateway according to your network settings.
If there is no router in your network, fill in the IP you get from your Internet Service
Provider (ISP). If there is a router in your network, make sure you have set the subnet
32
Hide quick links:
Advertisement
Table of Contents
