Table of Contents
Advertisement
ENR-1000 Series System Administrator's Manual
Configure Network Settings
There are two network interface cards in ENR.
Either of these cards can be supported by the built-in DHCP server feature, which enables
ENR to assign IP addresses to cameras via LAN1 or LAN2 port without another DHCP on
router.
By default, LAN1 card uses a fixed IP address 192.168.0.10, while LAN2 is in DHCP client
mode. It is suggested that you connect LAN1 to LAN and connect LAN2 to WAN.
Current IP Configurations
Go to Setup page Network tab.
IP Settings
On Network tab, click "Network Connection" then select the interface card that you wish to
set up. After setting up, please click "Save" on the bottom right side to save the settings.
LAN1 Configuration
LAN2 Configuration
97
www.acti.com
Hide quick links:
Advertisement
Table of Contents
