Table of Contents
Advertisement
ENR-1000 Series System Administrator's Manual
Please note that any change you make on this page requires the system to restart its service,
please wait for a while and reconnect ENR using the new properties.
Field Name
The connection port is used for remote web client to communicate with
HTTP Port
ENR. Default is 80.
Default uses
Default Gateway
Choose one connection type for this LAN port. DHCP and PPPoE service
will assign an IP Address to ENR, and there is no need for you to define
other network information.
Manual: Please obtain a static IP address and other network information
including Subnet Mask, Gateway and DNS server from your network
administrator.
Connection Type
DHCP: Use this connection type if you have a DHCP server on your
network router.
PPPoE: Chose this when your ISP is using PPPoE type DSL line. Please
contact you ISP to get the Username and Password for this connection.
LAN1 default is Manual; LAN2 default is DHCP.
IP Address
Fixed IP Address. LAN1 default is 192.168.0.10; LAN2 default is Auto.
Subnet Mask
Used to define if the destination is in the same subnet. LAN1 default is
255.255.255.0; LAN2 default is Auto.
Gateway
A valid gateway setting is essential for data transmission between
different subnets, such as accessing the DNS service or SMTP server
on the Internet. LAN1 default is 192.168.0.254; LAN2 default is Auto.
DNS Setting
The DNS server that translates domain names to actual IP addresses. If
this LAN is Manual mode, and you will set an SMTP server for event
notification, be sure to set the Primary DNS and Secondary DNS. LAN1
default is Manual; LAN2 default is Auto.
Enable DHCP Server
You may enable the built-in DHCP server for either LAN1 (default) or LAN2 port.
Go to Setup page Network tab click "DHCP Server".
1. Check "Enable" and select a LAN, this LAN has to be in Manual mode.
2. Set the Beginning IP Address and Ending Address, and click "Save". ENR will assign
IP addresses within this range to the cameras connected to the selected LAN port.
Please (1) make sure the cameras are in DHCP client mode, (2) connect and power the
cameras up after you enable this service.
Description
LAN2's
setting.
98
www.acti.com
Hide quick links:
Advertisement
Table of Contents
