Table of Contents
Advertisement
CHAPTER 11 TROUBLESHOOTING
B. Using Service Mode
1. Starting Service Mode
1) Open the front door, and insert the door switch actuator into the door switch
assembly.
•
To make checks in 'I/O display mode', for example, make the appropriate copying
mode settings before starting service mode.
2) Press the service mode switch (SSW) with a hex key.
•
The display indicates '[1]'.
•
A press on the Reset key ends service mode.
3) Enter the number of the mode you want to check or adjust using the keypad (Table
11-701), and press the OK key.
•
The copier starts the selected mode, and the display shows a number; for
example, indicating the first item under '301'.
4) Select the appropriate item of the selected service mode using the keypad while the
100s digit is flashing.
•
The display indicates the selected number. (The 100s digit flashes.)
•
A press on the Reset key returns the mode selection screen.
5) Press the OK key.
•
The copier starts the item indicated.
•
A press on the Clear key returns the item selection screen.
•
A press on the Reset key returns the mode selection screen.
6) Make the appropriate checks or adjustments.
7) End service mode.
•
A press on the Reset key returns the mode selection screen.
•
A press on the Reset key while the mode selection screen is being shown ends
service mode.
•
The copier does not end service mode even when the power switch is turned off
or the power plug is disconnected.
11-130
COPYRIGHT © 1997 CANON INC.
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
SSW
Figure 11-701
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Advertisement
Chapters
Table of Contents
Troubleshooting
