Table of Contents
Advertisement
Appendix
Appendix
Care
Wipe the base and handset with a damp cloth (use no solvent) or an antistatic cloth.
Never use a dry cloth. This can cause static.
Contact with liquid
If the handset should come into contact with liquid, on no account switch the device
on. Remove all batteries immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.
Questions and answers
If you have any questions about the use of your phone, you can contact us 24/7 at
www.siemens-mobile.com/customercare . You will find the most frequently asked
questions and answers below.
What has happened
when ...
... the display is blank?
... the handset fails to respond
to a key press?
... Base 1 or Searching for
Base, for example, is flashing
on the screen?
... the handset does not ring? The ringer is switched off.
... the incoming call number is
not displayed even though
CLIP is set?
100
!
Possible cause
The handset is not switched on.
The batteries are flat.
The keypad lock is activated.
The handset is outside the range
of the base.
The handset is not registered.
The base is not switched on.
Calling Line Identification is
blocked.
Possible solution
a
Press the end call key
for about 2 seconds.
Charge or replace the batteries
(page 9).
R
Press the hash key
for about 2 seconds to deacti-
vate the lock (page 10).
Move the handset nearer to the
base.
Register the handset
(page 14).
Check the power connector at
the base.
Switch on the ringer in the
handset (page 91) or the base
S150.
The caller must ask his network
provider to enable the identifi-
cation of his number (CLI).
Hide quick links:
Advertisement
Chapters
Table of Contents
