Table of Contents
Advertisement
zl3d
NAME
zl3d - Layer 3 daemon for the OpenArchitect switch.
SYNOPSIS
zl3d [-h <host_name>] [-t <msecs>] [-b] [-e] [-l] [-n] [-d
<level>] <iface ..>
DESCRIPTION
zl3d is run after the network interfaces are created and initialized with zconfig, and started
with ifconfig(1M). zl3d listens for Netlink messages from the kernel and monitors the
Linux network routing tables for routing updates. When an update occurs, if appropriate, zl3d
updates the corresponding routing tables in the silicon so that Layer 3 forwarding is done in the
switch at line speed. zl3d also ages the switch host route entries.
zl3d attempts to keep the Linux route cache and the switch host route table consistent. When a
host route table entry is in use, zl3d updates the Linux route cache. Host route table entries are
deleted when Linux removes the corresponding entry from the route cache. Similarly, network
route entries are removed when the corresponding Linux FIB table entry is deleted.
OPTIONS
-h <hostname>
monitors the OpenArchitect switch that is locally connected
(i.e., the one that is on the local PCI bus).
-t <msec> Sets the timeout value. By default, zl3d wakes up
every 15 seconds (15000 ms) to look for updates to the Linux
routing tables and to do aging processing of route table entries
on the switch.
-b
-e
table.
-l
-n
value to /proc/net/sys/ipv4/route/route_expires. The Linux kernel uses
this value as an expiration time for cache routes updated by
zl3d.
-d <level> Sets the level of debugging output required by zl3d.
The default level is one (1). Setting the debug level higher
Ethernet Switch Blade User's Guide
Downloaded from
www.Manualslib.com
Specifies which host to monitor. By default, zl3d
Do not background the zl3d process.
Enables additions of a default route to the L3 network route
Leave hardware tables intact on exit.
Writes the proc table entry. zl3d writes 3/2 of it's timeout
manuals search engine
release 3.2.2j
page 304
Advertisement
Table of Contents
Troubleshooting
