Table of Contents
Advertisement
Available languages
Available languages
42
What to do if...
Malfunction
After the check, activate the appliance. The programme continues from the point of interŠ
ruption.
If the malfunction occurs again, contact the service centre.
If the display shows other alarm codes, contact the service centre.
The necessary information for the service centre is on the rating plate.
Record this information:
– Model (MOD.) ........................................................
– Product number (PNC) ..........................................
– Serial number (S.N.) ..............................................
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the
dishes.
There are streaks, whitish
stains, or a bluish layer on
glasses and dishes.
Dry water drop stains on
glasses and dishes.
www.preciz.hu
Possible cause
The delay start is set.
Possible cause
The washing programme was
not applicable for the type of
load and soil.
You did not put the items corŠ
rectly in the baskets, water did
not touch all surfaces.
The spray arms could not turn
freely. Incorrect position of the
items in the baskets.
The filters are dirty or not asŠ
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect level of the water
softener adjustment.
The salt container cap is not
closed correctly.
The rinse aid quantity is too
high.
The rinse aid quantity is too
low.
Possible solution
• Cancel the delay start.
• When the countdown is
completed, the washing proŠ
gramme starts automaticalŠ
ly.
Possible solution
Make sure that the washing
programme is applicable for
the type of load and soil.
Put the items correctly in the
baskets.
Make sure that an incorrect poŠ
sition of the items do not cause
the blockage of the spray arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dishŠ
washer salt.
Adjust the water softener with
the correct level.
Make sure that the salt conŠ
tainer cap is closed correctly.
Decrease the rinse aid quantity.
Increase the rinse aid quantity.
Advertisement
Table of Contents
