free hit counter
  1. Manuals
  2. Brands
  3. Faber Manuals
  4. Indoor Fireplace
  5. VASKA C11
  6. Installation manual

Faber VASKA C11 Installation Manual

Hide thumbs Also See for VASKA C11:
Table of Contents

Advertisement

Quick Links

See also: User Manual
Enlarged version
Saturnus 8
NL-8448 CC Heerenveen
Postbus 219
NL-8440 AE Heerenveen
T. +31(0)513 656500
F. +31(0)513 656501
VASKA C11
gas -fireplace
installation guide

Advertisement

Table of Contents
loading

Related Manuals for Faber VASKA C11

Summary of Contents for Faber VASKA C11

  • Page 1 VASKA C11 gas -fireplace installation guide Saturnus 8 NL-8448 CC Heerenveen Postbus 219 NL-8440 AE Heerenveen T. +31(0)513 656500 F. +31(0)513 656501...

  • Page 2: Table Of Contents

    DESCRIPTION OF THE FIREPLACE CONTENTS 1. FOREWORD 2. INTRODUCTION 3. SAFETY INTRUCTIONS 4. INSTALLATION INSTRUCTIONS 4.1 Gas connection 4.2 Preparing placing of the appliance 5. PLACING OF THE APPLIANCE 6. DIRECT-VENT SYSTEM 6.1 Duct 6.2 Maximum flue length 6.3 Connection options 6.4 Preparing to install the Direct-vent system 1.

  • Page 3: Foreword

    The Direct-vent appliance are designed for installation in living areas The instructions for use are intended for the consumer and besides and are only to be used in combination with the Faber Direct-vent information about the use of your appliance, the booklet also system.

  • Page 4: Safety Intructions

    3. SAFETY INSTRUCTIONS The vent system and the opening must conform to local codes. This is a closed device in a framed-in space, a device without a fan Safety and general information. and with a chimney loss of more than 17% (not condensed). The natural draught makes it necessary that the intake and exhaust Before installation, ensure that the local distribution conditions are at the same pressure.

  • Page 5: Gas Connection

    4. INSTRUCTIONS FOR INSTALLATION Note: Since the appliance is a source of heat, circulation of air occurs. 4.1 GAS CONNECTION Therefore it is of importance that you do not use the appliance shortly after a renovation of the home. Because of the natural circulation of air, moist and volatile components from paint, building materials, A G3/8"...

  • Page 6: 5. Placing Of The Appliance

    Note! To ensure proper burning, the log set may only be arranged flexible inner pipe (ø 100 mm) with the outer pipe through the according to the instructions provided by Faber International (see fig. chimney connector plate and then fasten it to the Direct-vent 2).

  • Page 7: Direct-Vent System

    6. DIRECT-VENT SYSTEM 6.3 CONNECTION OPTIONS The Direct-vent system can be connected in the following ways: 6.1 DUCT 1) through the wall, with or without a horizontal run; 2) through the roof, with or without a horizontal run; The Direct-vent system has standard sizes for its intake and exhaust 3) through an existing chimney.

  • Page 8: Preparing To Install The Direct-Vent System

    6.3.4 Roof vent with 2 45-degree bends The chimney itself is used for the air supply. The flexible piping One meter of vertical vent pipe is always required first. Then serves as the flue. It is therefore essential that the chimney is sealed a passage with two 45-degree bends is permitted up to the at both the top and bottom.

  • Page 9: Installing The Direct-Vent System

    6.5 INSTALLING THE DIRECT-VENT SYSTEM 7. Connect the roof vent unit to the vertical pipes. 6.5.1 Connecting the appliance You can install the vent pipe before installing the appliance and Install the concentric pipes in the connector on the device and shove make the connection to the vent opening on the appliance with a them into place.

  • Page 10: Burner

    7. CLEANING AND MAINTENANCE Shove the sawed off outer pipe into the chimney vent unit through the rubber ring. Now position the device with the sawed off inner pipe attached. The appliance must be cleaned and checked annually by an authorized installer.

  • Page 11: Burner And Control Block

    7.4BURNER AND CONTROL BLOCK 7.5 GAS CONTROL A Adjusting screw pilot burner B Reduced injector C Gas pressure for burner pressure D Gas pressure for pre pressure E Pressure adjuster burner pressure fig. 3 frontal view Vaska 1. Oxypilot 2. Burner 3.

  • Page 12: Faults

    8. FAULTS 9. DISPOSAL OF THE PACKAGING AND THE APPLIANCE PROBLEM CAUSE SOLUTION Appliance will not light or - Air in supply pipe (after - Venting. The appliance packaging is recyclable. The packaging could include goes out. appliance has been out of the following materials: operation)..

  • Page 13: Appendix 1

    APPENDIX 1 Technical data Country Category I2E+ IH/S I2E+ Model type C11/C31 C11/C31 C11/C31 C11/C31 C11/C31 C11/C31 C11/C31 C11/C31 C11/C31 C11/C31 C11/C31 C11/C31 C11/C31 Heat input Hi Efficiency class Type of gas Gas supply pressure mbar Gas usage at full load l/h (15 °C, 1013 mbar) 650 Burner pressure...

Table of Contents