To Light The Burner; To Extinguish The Burner; Power Failure - AGA GC3 (P/F) User Instructions

Three oven gas fired power flue cooker with aims

Hide thumbs Also See for GC3 (P/F):

Installation instructions manual (20 pages)

User instructions (16 pages)

Installation instructions manual (12 pages)

Table Of Contents

Table of Contents

CAUTION: BEFORE LIGHTING: ENSURE KNOB (A) IS IN THE OFF POSITION (SEE FIG. 5).

ALSO ENSURE GAS SUPPLY TO COOKER IS ON, AND THE SERVICE GAS COCK (C) IS

IN THE ON POSITION (SEE FIG. 3), AND THE ELECTRICAL SUPPLY TO THE AGA IS

SWITCHED ON.

LIGHTING PROCEDURE SEE FIGS. 4 - 9B

The main burner gas flow is set with the 'temperature knob' (B). (See Fig. 4). First ensure

both knobs are turned fully clockwise. Knob (A) to the OFF position and knob (B) to the

minimum setting (thin end of white band).

Turn 'ON/OFF' knob (A) slightly anti-clockwise towards the ignition position (

reaching stop, press down and hold for 5 seconds (gas flows only to the pilot burner). (See

Fig. 6).

Continue pressing down knob (A) while turning further anti-clockwise to the PILOT position

(See Fig. 7) (this activates the piezo) continue to hold down for 10 seconds after pilot

burner has been lit. (If the pilot does not light, steps 2 and 3 can be repeated).

Upon lighting, release knob and turn further anti-clockwise to the 'ON' position (large flame

symbol) (See Fig. 8). Pilot gas flows and mains gas flows according to the temperature

setting (knob B).

Turn the temperature knob (B) slightly anti-clockwise into the white band (LOW FIRE

position) (See Fig. 9A). Leave in the low fire position for at least 30 minutes.

NOTE: Low fire position is attained by turning knob (B) gradually into the white band until small

flame is observed through viewing window (F).

After 30 minutes rotate control knob (B) anti-clockwise to the mid-position of the green band

for normal running (See Fig. 9B).

NOTE: After several hours the heat indicator should be within the black band on the AIMS

handset 'INFORMATION' screen. It may be necessary to adjust the control knob in the green

band to achieve this, allow the cooker to stabilise for at least for hours before attempting any

further adjustment.

When the cooker is lit from cold, moisture may form on the enamel which should be wiped off to

prevent staining.

IF THE FLAME HAS EXTINGUISHED FOR WHATEVER REASON, WAIT THREE MINUTES

(MINIMUM) BEFORE RE-LIGHTING.

Turn ON/OFF knob (A) clockwise until reaching stop (PILOT) position.

Press down slightly and continue turning clockwise from pilot position to the OFF position

(See Fig. 5).

NOTE: LPG APPLIANCE ONLY: When the cooker is turned off a noticeably loud pop

will be heard. This is quite normal.

When the burner has cooled sufficiently, pilot lighting instructions may be repeated.

In the event of power failure your appliance will become inoperative. When the power is restored

it will automatically restart.