Table of Contents
Advertisement
Step 3: Changing Your System From The Residential To The
Commercial or Basic Plans:
Your Valet Digital is pre-programmed at the factory on the Residential Standard Plan. If you
wish to change to the Commercial or Basic Plans, please follow the procedure below.
1. Turn the Main Control Unit off via the key switch.
2. After waiting at least 5 seconds, turn the main control unit key switch back to the on
position.
3. The RED LED indicator on the main control unit will now flash very quickly.
4. Immediately press and hold either Button 1 to select the Residential Standard plan or
Button 2 to select the Commercial Plan, or Buttons 1 & 2 together simultaneously to
select the Basic Plan. Keep the selected button/s depressed until the confirmation beeps
are heard (approx 5 seconds).
5. One beep = Residential Standard Plan, Two beeps = Commercial Standard Plan, Three
Beeps = Residential Basic Plan
TO CHANGE BETWEEN PLANS
1.
2.
3.
4.
Press & hold
button/s until unit
beeps.
5.
COMPLETE
PLEASE NOTE: If you wish to change back to the Residential Standard Plan after registering your system,
you must notify the VALET Monitoring Centre by speaking to an operator on 1300 302 293.
Turn the Main control Unit off via the key switch.
After waiting at least 5 seconds, turn the main
control unit key switch back to the on position.
The RED LED indicator on the main control unit will
now flash very quickly.
Immediately press and hold down the necessary
button/s for your selected plan (Button 1 =
Residential Standard Plan, Button 2 = Commercial
Standard Plan, Buttons 1&2 together = Residential
Basic
Plan)
on
confirmation beeps are heard (approx 5 seconds).
One beep = Residential Standard Plan, Two beeps
= Commercial Plan, Three beeps = Residential
Basic Plan
a
remote
control
25
until
the
Advertisement
Table of Contents
