Table of Contents
Advertisement
Note: If you scan the Off barcode, both the aimer and illumination
lights turn off, making it difficult to scan barcodes in low light. To
turn the LED Power Level back on, move to a brightly lit area and
scan either the Low or the High barcode below.
Illumination Lights
If you want the illumination lights on while reading a barcode, scan
the Lights On barcode, below. However, if you want to turn just the
lights off, scan the Lights Off barcode.
Note: This setting does not affect the aimer light. The aiming light
can be set using
Scanner Time-Out
Scanner Time-Out powers down the scanner after the unit has been
idle for the specified time. To prevent the scanner from powering
down, set this time-out to 0. Scan the barcode below, then set the
time-out by scanning digits (from 0 -999,999 ms) from the inside
back cover, then scanning Save. Default = 1 ms.
LED Power Level
Off
*High (100%)
Illumination Light
*Lights On
Scanner Time-Out
Scanner Time-Out
Aimer Modes.
Low (50%)
Lights Off
24
Advertisement
Table of Contents
