Harman XXV Owner's Manual page 24

Hide thumbs Also See for XXV:

B u r n

and Maintenance

1. Scrape the top holed surface and sides of the burn

pot.(Fig 39) It is not necessary to completely remove

all loose material from the burn pot. The excess will be

pushed out during the next use.

DANGER

Disconnect the power to the unit before

removing cover.

2. Loosen the (2) wiqg thumb screws on the lower

front angle of the burn pot. (Fig. 39)

3. Lift off the clean-out cover (Fig.40) to open the bottom

clean-out chamber. (Fig.41)

4. Clean ash buildup from inside the chamber while

Fig.

cover is off. Use the scraper to tap on the top front

edge of the burn pot. This will help knock pieces of

ash, loosened by the scraping process, down through

the holes. It also helps knock scale off of the igniter

element.

F & J J y &

The igniter is made to be removable for service

by insulated malelfemale wire connectors. These

connections between the hot leads (the wires inside

the burn pot) and the cold leads (the wires from the

control board) are always pulled to the inside rear of

the feeder body. (Not coiled inside the burn pot.)

It is very important that these connections are

to the inside rear of the feeder body. Also, the extra

wire of the igniter wire service loop must be pulled out

through the rear of the feeder and tied up so that it will

Fig. 40

not be damaged by any moving parts.

Note: 'The hot leadlcold lead connection must

always be pulled to the rear of the feeder

body before operation.

Use caution when cleaning burn pot clean-

out chamber. Do not damage the high

temperature igniter wires.

XXV Pellet Stove