Configuring Clear Channel T3/E3 and Channelized T3 and T1/E1 Controllers on the Cisco ASR 9000 Series Router
•
Restrictions
If you configure an option that is not valid for your controller type, you receive an error when you
commit the configuration.
Before you configure an E1 controller on the 8-Port Channelized T1/E1 SPA, consider the following
restrictions:
•
•
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
OL-32684-01
Configure an STS stream channelized for T3. For more information, see the
–
Channelized SONET/SDH on the Cisco ASR 9000 Series Router"
–
Configure a channelized T3 controller running in E1 mode, as described in the
Channelized T3 Controller" section on page
If you have a 4-Port Channelized T3/DS0 SPA, you must configure a channelized T3 controller to
run in E1 mode, as described in the
The SPA controller is not visible until it is explicitly configured for E1 mode.
For each individual SPA, the SPA ports must all be in the same mode (all E1).
show controllers e1 interface-path-id
configure
controller e1 interface-path-id
clock source {internal | line}
framing {crc4 | no-crc4 | unframed}
national bits bits
no shutdown
channel-group channel-group-number
timeslots range
speed kbps
exit
Repeat Step 8 through Step 11 to assign time slots to a channel group. Each controller can contain
up to 24 time slots.
exit
Repeat Step 2 through Step 13 to assign more channel groups to a controller as desired.
end
or
commit
Cisco ASR 9000 Aggregation Services Router Interface and Hardware Component Configuration Guide
How to Configure Clear Channel T3/E3 Controllers and Channelized T1/E1 Controllers
461.
"Configuring a Channelized T3 Controller" section on page
"Configuring
module.
"Configuring a
461.
471