Table of Contents
Advertisement
Troubleshooting
Problem
Main rotor blades are shaking in
flying.
Helicopter is out of control when
it takes off.
The sound of the main rotor be-
comes smaller.
Helicopter has no reaction or can
not fly smoothly.
Receive board Interface Diagram
Tail Motor
Main motor
Aileron
Elevator
13000000 XciteRC Flybarless Trainer 200
13000000 XciteRC Flybarless Trainer 200
Possible cause
Lateral axis is bent; lateral axis
screw is not tight. There are
some debris in the servo, caus-
ing shakes, The loose between
the swash plates. Deformed or
damaged tail rotor blades.
The helicopter isn´t maintained
static level when it is binding.
Low battery voltage of helicopter.
Failure to binding.
Solution
Replace the lateral axis. Tighten
the lateral axis screw. Change
the bearing. Remove he servo
and clear debris. Compress the
swash plates. Change tail rotor
blades.
Rebind the TX and RX correctly.
Charge the battery or change a
fully charged battery.
Rebind the helicopter and trans-
mitter, make sure you place the
helicopter static level next to the
transmitter.
EN
19
Advertisement
Table of Contents
Troubleshooting
