Table of Contents
Advertisement
CHAPTER 4 PROGRAMMING WITH COMMANDS
Adding an escape point before the sewing start point
The following describes how to set the escape point A before the sewing start point.
* The escape point is a provisional point provided for preventing the work clamp from interfering with the needle or presser foot
when the work clamp is lifted at the start point.
1. Carry out step 1 of "Procedure for modifying
program" to call program.
2. Press
, and then press
The work clamp moves to the sewing start point.
3. Press
.
4. Move the work clamp with
the needle point is at A of the pattern sheet.
Record the coordinates (values of
5. Press
.
A is programmed.
6. Press
.
7. Move the work clamp with
equivalent of the coordinate value recorded in
step 4 in the opposite direction so that the
needle point is at 1 of the pattern sheet.
A is programmed.
114
8. Press
.
9. Press
10. Press
so that
11. Input the number of stitches to be deleted, and
and
).
12. Carry out steps 3 and 4 of "Procedure for
an
PD-3000
.
1 is programmed again.
, and then press
The work clamp moves to the sewing start point.
.
then press
.
In the example, the first stitch is deleted.
.
The needle point moves to A.
modifying program" to save program.
.
Press
- Quick Links:
- Instruction Manual
Hide quick links:
Advertisement
Table of Contents
