Need Only A Quick Start; To Set Up And Install The Switch In Your Network - HP procurve switch 2600 series Access Security Manual
Hide thumbs
Also See for procurve switch 2600 series:
- Installation and getting started manual (116 pages) ,
- Manual (300 pages) ,
- Management and configuration manual (547 pages)
Table of Contents
Advertisement
Getting Started
Need Only a Quick Start?
1-10
If you need further information on Hewlett-Packard switch tech
■
nology, visit the HP ProCurve website at:
http://www.hp.com/go/hpprocurve
Need Only a Quick Start?
IP Addressing. If you just want to give the switch an IP address, or if you
are not using VLANs, HP recommends that you use the Switch Setup screen
to quickly configure IP addressing. To do so, do one of the following:
Enter setup at the CLI Manager level prompt.
■
HPswitch# setup
In the Main Menu of the Menu interface, select
■
8. Run Setup
For more on using the Switch Setup screen, refer to the Installation and
Getting Started Guide you received with the switch.
To Set Up and Install the Switch in Your
Network
Use the Installation and Getting Started Guide for your switch model
(shipped with the switch) for the following:
Notes, cautions, and warnings related to installing and using the
■
switch and its related modules
Instructions for physically installing the switch in your network
■
■
Quickly assigning an IP address and subnet mask, set a Manager
password, and (optionally) configure other basic features.
Advertisement
Table of Contents
