Alarm Callbacks; Figure 6-6 Alarm Handling Options - Honeywell Rapid Eye Operator's Manual
Remote view
Hide thumbs
Also See for Rapid Eye:
- Administrator's manual (294 pages) ,
- System administration manual (292 pages) ,
- System administrator manual (264 pages)
Table of Contents
Advertisement
Alarms from Events
Make sure that the file
location for saved clips
exists to confirm that they
will be saved.
Alarm Callbacks
82
The user can enable the Automatic Rearm feature from the Alarm Handling Options window
(opened with the Rapid Eye View application, View menu
shown in
Figure
6-6.
Figure 6-6
Alarm Handling Options
Please note that:
•
When the Rapid Eye software is installed and started for the first time, it does not have
any information about the alarms that are not rearmed. Therefore automatically
rearming alarms will not be supported on the initial startup. After the application has
been running and alarm callbacks are received, it maintains information about the
status of the alarms (Rearmed / Not Rearmed). If the application shuts down in the
middle of clip creation, pending Input Activated and Motion alarms will be
automatically rearmed the next time the application starts.
•
The Automatic Rearm feature is system dependent. That is, this feature will be
supported only from the server that has been configured as the Alarm Station.
•
While trying to automatically rearm, if any of the sites are unreachable, alarms from
those sites will remain in their non-rearmed state.
Note
Recording is enabled on the cameras where alarms are expected. If recording
is not enabled, clips will not be automatically created and the corresponding
alarm will not be automatically rearmed. Operators will have to manually
rearm alarms with an Alarm session.
Options
Alarm Handling),
Advertisement
Table of Contents
Troubleshooting
