Using Ac Power; Attaching The Viewfinder; Attaching The Supplied Viewfinder - Sony PMW-350K Operating Instructions Manual
Solid-state memory
camcorder
Hide thumbs
Also See for PMW-350K:
- Operating instructions manual (183 pages) ,
- Manual (37 pages) ,
- Brochure & specs (35 pages)
Table of Contents
Advertisement
Notes
• During recording and playback (while the ACCESS
lamp on the right-side panel is lit in blue and the
ACCESS lamp in the card slot section is lit in orange),
be careful never to remove the battery pack.
• Make sure to power the camcorder off before replacing
the battery pack.
Using AC Power
Mount an AC-DN2B/DN10 on the camcorder in
the same way as a battery pack, then connect to
the AC power supply.
The AC-DN2B/DN10 can supply up to 100 W of
power.
32
Attaching the Viewfinder
Release button
To an AC outlet
Attaching the Viewfinder
CAUTION
When the viewfinder is attached, do not leave the
camcorder with the eyepiece facing the sun. Direct
sunlight can enter through the eyepiece, be focused in the
viewfinder and cause fire.
Attaching the Supplied Viewfinder
Note
When attaching the viewfinder, make notes of the
following points.
• Be sure to power off the camcorder before coupling the
viewfinder connector to the camcorder's VF connector
(26-pin). If you make this connection when the
camcorder power is on, the viewfinder may not
function properly.
• Couple the viewfinder connector firmly to the
camcorder's VF connector (26-pin). If the coupling is
loose, noise may appear on the video or the tally
indicator may not operate properly.
1
1 Loosen the viewfinder left-to-right
positioning ring, 2 attach the
viewfinder to the viewfinder fitting
shoe, and 3 tighten the viewfinder left-
to-right positioning ring.
Stopper
Viewfinder left-
to-right
positioning ring
Advertisement
Table of Contents
