Match Ip Dscp - Dell S4810 Reference Manual

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

To access this command, enter the class-map command. After the class map is

identified, you can configure the match criteria. For class-map match-any, a

maximum of five ACL match criteria are allowed. For class-map match-all,

only one ACL match criteria is allowed.

match ip dscp

Use a differentiated services code point (DSCP) value as a match criteria.

match ip dscp dscp-list [set-ip-dscp value]

To remove a DSCP value as a match criteria, use the no match ip dscp dscp-

list [set-ip-dscp value] command.

CLASS-MAP CONFIGURATION (config-class-map)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Quality of Service (QoS)

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

— identifies the class map.

Enter the IP DSCP values that is to be the match criteria.

Separate values by commas — no spaces ( 1,2,3 ) or indicate

a list of values separated by a hyphen (1-3). The range is from

(OPTIONAL) Enter the keywords set-ip-dscp then the IP

DSCP value. The matched traffic is marked with the DSCP

value. The range is from 0 to 63.

Show Quick Links

Table of Contents