Stacking - Dell S4810 Reference Manual

Table of Contents

Stacking

All commands in this chapter are specific to the Dell Networking operating software on the S4810

The commands are always available and operational, whether the S-Series has a stacking module

inserted. You can use the commands to pre-configure a switch, so that the configuration settings are

invoked when the switch is attached to other S-Series units.

For information about using the S-Series stacking feature, refer to the "Stacking S-Series Switches"

chapter in the Dell Networking OS Configuration Guide.

CAUTION: You cannot enable stacking simultaneously with virtual link trunking (VLT). If you

enable both at the same time, unexpected behavior occurs.

The Dell Networking OS commands for data center bridging features include 802.1Qbb priority-based

flow control (PFC), 802.1Qaz enhanced transmission selection (ETS), and the data center bridging

exchange (DCBX) protocol.

redundancy disable-auto-reboot

Prevent the S-Series stack management unit, stack member unit, and standby unit from rebooting if they

redundancy disable-auto-reboot [stack-unit] [members | 0-11]

To return to the default, use the no redundancy disable-auto-reboot

stack-unit command.

Disabled (the failed switch is automatically rebooted).

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Enter the stack-unit number. For the S4810, the range is

from 0 to 5.

This is all stack-units.

Show Quick Links

Table of Contents