Protocol Spanning-Tree - Dell S4810 Reference Manual
Hide thumbs
Also See for S4810:
- Reference manual (1759 pages) ,
- Installing manual (58 pages) ,
- Configuration manual (17 pages)
Table of Contents
Advertisement
Version 7.5.1.0
pre-Version
6.2.1.1
Related
forward-delay
Commands
state.
hello-time
protocol spanning-tree
To enable and configure the spanning tree group, enter SPANNING TREE mode.
S4810
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, use the no protocol spanning-tree
stp-id command.
Parameters
stp-id
Defaults
Not configured.
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
1634
Introduced on the C-Series.
Introduced on the E-Series.
— changes the wait time before STP transitions to the Forwarding
— changes the time interval between BPDUs.
Enter zero (0). Dell Networking OS supports one spanning
tree group, group 0.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Spanning Tree Protocol (STP)
- Quick Links:
- Boot System
- Restore Factory-Defaults
Hide quick links:
Advertisement
Table of Contents
