Setenv - Dell S4810 Reference Manual
Hide thumbs
Also See for S4810:
- Reference manual (1759 pages) ,
- Installing manual (58 pages) ,
- Configuration manual (17 pages)
Table of Contents
Advertisement
setenv
Configure system settings.
S4810
Syntax
setenv [gatewayip address | primary_image f10boot location |
secondary_image f10boot location | default_image f10boot
location | ipaddre address | ethaddr address | enablepwdignore
| stconfigignore]
Parameters
gatewayip
address
primary_image
secondary_ima
ge
default_image
location
ipaddr
ethaddr
address
enablepwdigno
re
stconfigignore
Command
uBoot
Modes
1664
Enter the IP address for the default gateway.
Enter the keywords primary_image to configure the boot
parameters used in the first attempt to boot Dell Networking
OS.
Enter the keywords secondary_image to configure boot
parameters used if the primary operating system boot
selection is not available.
Enter the keywords default_image to configure boot
parameters used if the secondary operating system boot
parameter selection is not available.
NOTE: The default location should always be the internal
flash device (flash:), and a verified image should be
stored there.
Enter the location of the image file to be loaded. When using
this command, the keyword f10boot must precede the
location. For example, primary_image f10boot tftp://
10.10.10.10/server.
Enter the keyword ippaddr to configure the system
management IP address.
Enter the keyword ethaddr to configure system
management MAC address.
Enter the IP address in standard IPv4 format and the MAC
address in standard MAC format.
Enter the keywords enableprdignore true to reload the
system software without the enable password configured.
Enter the keywords stconfigignore true to ignore the
startup configuration file when reloading the system.
u-Boot
- Quick Links:
- Boot System
- Restore Factory-Defaults
Hide quick links:
Advertisement
Table of Contents
