Tunnel Source - Dell S4810 Reference Manual

Table of Contents

Configuration of IPv6 commands over decapsulate-any tunnel causes an error.

tunnel source

Set a source address for the tunnel.

tunnel source {ip-address | ipv6–address | interface-type-

number | anylocal}

To delete the current tunnel source address, use the no tunnel source

ipv6–address

interface-type-

INTERFACE TUNNEL (conf-if-tu)

Version 9.4(0.0)

Version 9.2(0.0)

Added an optional keyword "anylocal" to the tunnel source command. The

anylocal argument can be used in place of the ip address or interface, but only with

the multipoint receive-only mode tunnels. The tunnel source anylocal command

allows the multipoint receive-only tunnel to decapsulate tunnel packets addressed

Enter the source IPv4 address in A.B.C.D format.

Enter the source IPv6 address in X:X:X:X::X format.

For a 100/1000 Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a 1–Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a port channel interface, enter the keywords port-

channel then a number from 1 to 128.

For a 10–Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Enter the anylocal command to allow the multipoint

receive-only tunnel to decapsulate tunnel packets destined

to any local ip address.

Added the tunnel source anylocal command.

Introduced on the MXL 10/40GbE Switch IO Module.

Show Quick Links

Table of Contents