Tunnel Destination - Dell S4810 Reference Manual

Table of Contents

tunnel destination

Set a destination endpoint for the tunnel.

tunnel destination {ip-address | ipv6–address}

To delete a tunnel destination address, use the no tunnel destination {ip-

address | ipv6–address} command.

ipv6–address

INTERFACE TUNNEL (conf-if-tu)

Version 9.3(0.0)

The tunnel interface is inoperable without a valid tunnel destination address for the

configured Tunnel mode.

To establish a logical tunnel to the particular destination address, use the

destination address of the outer tunnel header. If you configure a tunnel interface

or source address, the tunnel destination must be compatible.

ip unnumbered

Configure a tunnel interface to operate without a unique IPv4 address and select the interface from

which the tunnel borrows its address.

ip unnumbered {interface-type interface-number}

To set the tunnel back to default logical address use the no ip unnumbered

command. If the tunnel was previously operational, the tunnel interface is

operationally down unless you also configure the tunnel IPv6 address.

interface-type

Enter the destination IPv4 address for the tunnel.

Enter the destination IPv6 address for the tunnel.

Introduced on the S4810, S4820T, S6000 and Z9000.

Enter the interface type, followed by a slot number.

Show Quick Links

Table of Contents