Ipv6 Unnumbered - Dell S4810 Reference Manual
Hide thumbs
Also See for S4810:
- Reference manual (1759 pages) ,
- Installing manual (58 pages) ,
- Configuration manual (17 pages)
Table of Contents
Advertisement
Defaults
None
Command
INTERFACE TUNNEL
Modes
Command
Version 9.4(0.0)
History
Usage
The ip unnumbered command fails in two conditions:
Information
•
•
To ping the unnumbered tunnels, the logical address route information must be
present at both the ends.
NOTE: The ip unnumbered command can specify an interface name that does not exist or does
not have a configured IPv6 address. The tunnel interface is not changed to operationally up until
logical ip address is identified from the one of the address family.
ipv6 unnumbered
Configure a tunnel interface to operate without a unique IPv6 address and select the interface from
which the tunnel borrows its address.
S4810
Syntax
ipv6 unnumbered {interface-type interface-number}
To set the tunnel back to default logical address use the no ipv6 unnumbered
command. If the tunnel was previously operational, the tunnel interface is
operationally down unless you also configure the tunnel IPv4 address.
Parameters
interface-type
interface-
number
Defaults
None.
Command
INTERFACE TUNNEL
Modes
Command
Version 9.4(0.0)
History
Usage
The ip unnumbered command fails in two conditions:
Information
•
1674
Introduced on the S4810, S4820T, S6000 and Z9000.
If the logical ip address is configured.
If Tunnel mode is ipv6ip (where ip address over tunnel interface is not possible).
Enter the interface type, followed by the type, slot and port
information.
Introduced on the S4810, S4820T, S6000 and Z9000.
If the logical ip address is configured.
Tunneling
- Quick Links:
- Boot System
- Restore Factory-Defaults
Hide quick links:
Advertisement
Table of Contents
