Downstream Disable Links - Dell S4810 Reference Manual
Hide thumbs
Also See for S4810:
- Reference manual (1759 pages) ,
- Installing manual (58 pages) ,
- Configuration manual (17 pages)
Table of Contents
Advertisement
Version
8.3.12.0
Version 8.4.2.3
Related
•
Commands
•
downstream disable links
Configure the number of downstream links in the uplink-state group that are disabled if one upstream
link in an uplink-state group goes down.
S4810
Syntax
downstream disable links {number |all}
To revert to the default setting, use the no downstream disable links
command.
Parameters
number
all
Defaults
No downstream links are disabled when an upstream link in an uplink-state group
goes down.
Command
UPLINK-STATE-GROUP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version
8.3.19.0
Version
8.3.12.0
Version 8.4.2.3
1682
Introduced on the S4810.
Introduced on the S-Series S50.
downstream
— assigns a port or port-channel to the uplink-state group as a
downstream interface.
uplink-state-group
— creates an uplink-state group and enables the tracking of
upstream links.
Enter the number of downstream links to be brought down
by UFD. The range is from 1 to 1024.
Brings down all downstream links in the group.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
Uplink Failure Detection (UFD)
- Quick Links:
- Boot System
- Restore Factory-Defaults
Hide quick links:
Advertisement
Table of Contents
