Peer-Routing-Timeout - Dell S4810 Reference Manual
Hide thumbs
Also See for S4810:
- Reference manual (1759 pages) ,
- Installing manual (58 pages) ,
- Configuration manual (17 pages)
Table of Contents
Advertisement
Version 9.2(0.2)
peer-routing-timeout
Configure the delay after which peer routing is disabled when the peer is unavailable. This command is
applicable for both IPV6/ IPV4.
S4810
Syntax
peer-routing-timeout value
To restore the default value, use the no peer-routing-timeout command.
Parameters
value
Command
VLT DOMAIN (conf-vlt-domain)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0)
Version 9.2(0.2)
Version 9.0.2.0
Usage
When the timer expires, the software checks to see if the VLT peer is now available.
Information
If the VLT peer is not available, peer-routing is disabled on that peer.
primary-priority
Assign the priority for master election among VLT peers.
S4810
Syntax
[no] primary-priority
Parameters
value
1724
Introduced on the Z9000, S4810, and S4820T.
Enter the timeout value in seconds. The range is from 1 to
65535. The default value is 0 (no timeout).
Added the support for IPV6 / IPV4.
Introduced on the Z9000, S4810, and S4820T.
Introduced on the S6000.
To configure the primary role on a VLT peer, enter a lower
value than the priority value of the remote peer. The range is
from 1 to 65535.
Virtual Link Trunking (VLT)
- Quick Links:
- Boot System
- Restore Factory-Defaults
Hide quick links:
Advertisement
Table of Contents
