Vlt-Peer-Lag Port-Channel - Dell S4810 Reference Manual
Hide thumbs
Also See for S4810:
- Reference manual (1759 pages) ,
- Installing manual (58 pages) ,
- Configuration manual (17 pages)
Table of Contents
Advertisement
Version 8.3.8.0
Usage
The VLT domain ID must be the same between the two VLT devices. If the domain
Information
ID is not the same, a syslog message is generated and VLT does not launch.
Related
show vlt
Commands
value.
vlt-peer-lag port-channel
Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to
an attached device.
S4810
Syntax
vlt-peer-lag port-channel id-number
Parameters
id-number
Defaults
Not configured.
Command
INTERFACE PORT-CHANNEL
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.8.0
Virtual Link Trunking (VLT)
Introduced on the S4810.
— uses the show vlt brief command to display the delay-restore
Enter the respective vlt port-channel number of the peer
device.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
1737
- Quick Links:
- Boot System
- Restore Factory-Defaults
Hide quick links:
Advertisement
Table of Contents
